Section 03 100
Part 1 -- GENERAL
SCOPE OF WORK
The Contractor shall provide all labor, materials, tools and equipment required to furnish and install concrete formwork complete with all necessary accessories, as described in this section and as shown on the Contract Drawings.
The Contractor shall provide descriptive submittals in accordance with the provisions of Section 01001 of these Specifications. Submittals include, but are not limited to, the following:
Catalog data, manufacturers and other data needed to prove compliance with the requirements of the section and the referenced documents.
Submit with concrete shop drawings manufacturers data on any form coatings, linings, ties or pre-manufactured form systems used. Submittals must be reviewed by Architect prior to concrete placement.
Notify Architect for inspection of all formwork prior to placement of concrete. Notification shall be given at least two weekdays before the placement is scheduled.
Conform to the requirements ofthe American Concrete Institute's "Recommended Practice for Concrete formwork" (ACI347), and "Specifications for Structural Concrete for Buildings" (ACI 301). Conform to the American Concrete Institute "Building Code Requirements for Reinforced Concrete" (ACI
Design of formwork is the Contractor's responsibility. The Engineer/Architect's review of the Shop Drawings as submitted or as corrected in no way relieves the Contractor of his responsibility for adequately constructing and maintaining the forms so that they will function properly.