X hits on this document

860 views

0 shares

0 downloads

0 comments

154 / 324

11103 (R 05106)

D.

Qualification Data: For mctal"plate manufacturer, fabricator and Installer.

E.

ResearchlEvaluation Reports: For the following, showing compliance with building code in effect for Project:

1. 2 .

MetaI"plate connectors. Metal truss accessories .

1.4

QUALITY ASSURANCE

A.

Metal Connector-Plate Manufacturer Qualifications: A manufacturer that is a member of TPI and that complies with quality-control procedures in TPI 1 for manufacture of connector plates.

1.

Manufacturer's responsibilities include providing professional

engineering services

needed to assume engineering responsibility.

2.

Engineering

Responsibility:

Preparation

of

Shop

Drawings

and comprehensive

engineering analysis

by a qualified professional

engineer.

B.

Fabricator Qualifications: Shop that participates in a recognized quality-assurance program that complies with quality-control procedures in TPI 1 and that involves third-party inspection by an independent testing and inspecting agency acceptable to Architect and authorities having jurisdiction.

  • C.

    Comply with applicable requirements and recommendations of the following publications:

    • 1.

      TPI 1, "National Design Standard for Metal Plate Connected Wood Truss Construction."

    • 2.

      TPI DSB, "Recommended Design Specification for Temporary Bracing of Metal Plate Connected Wood Trusses."

    • 3.

      TPI HID, flCommentary and Recommendations for Handling, Installing & Bracing Metal Plate Connected Wood Trusses."

D.

Wood Structural Design Standard:

Comply with applicable requirements

m

AF&P A's

"National

Design

Specifications

for

Wood

Construction"

and

its

"Supplement."

E.

Forest Certification: Provide metal-plate-connected wood trusses produced from wood obtained from forests certified by an FSC-accredited certification body to comply with FSC STD-O1-001, "FSC Principles and Criteria for Forest Stewardship."

PART 2 - PRODUCTS

    • 2.1

      DIMENSION LUMBER

      • A.

        Lumber: DOC PS 20. Provide lumber that complies with the applicable rules of any rules writing agency certified by the ALSC Board of Review. Provide lumber graded by an agency certified by the ALSC Board of Review to inspect and grade lumber under the rules indicated.

1.

Provide dry lumber with 19 percent maximum moisture content at time of dressing.

SHOP-FABRICATED WOOD TRUSSES

061753 -2

Document info
Document views860
Page views860
Page last viewedThu Dec 08 18:51:43 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments