X hits on this document

856 views

0 shares

0 downloads

0 comments

155 / 324

11103 (R 05/06)

  • B.

    Grade and Species: For truss chord and web members, provide dimension lumber of any species, graded visually or mechanically, and capable of supporting required loads without exceeding allowable design values according to AF&PNs "National Design Specifications for Wood Construction" and its "Supplement."

  • C.

    Permanent Bracing: Provide wood bracing that complies with requirements for miscellaneous lumber in Division 06 Section-Rough Carpentry.

2.2

METAL PRODUCTS

A.

Connector Plates: Fabricate connector plates to comply with TPI 1 from hot-dip galvanized steel sheet complying with ASTM A 653/A 653M; Structural Steel (SS), high-strength low alloy steel Type A (lISLAS Type A), or high-strength low-alloy steel Type B (HSLAS Type B); G60 (ZI80) coating designation; and not less than 0.036 inch (0.9 mm) thick

1.

Available Manufacturers:

Subject to compliance with requirements, manufacturers

2.

offering products that may be incorporated into the Work the following: Manufacturers: Subject to compliance with requirements, following:

include, but are not limited to,

provide products by one of the

B.

  • a.

    Alpine Engineered Products, Inc.

  • b.

    Cherokee Metal Products, Inc.; Masengill Machinery Company.

  • c.

    CompuTrus, Inc.

  • d.

    Eagle Metal Products.

  • e.

    Jager Building Systems, Inc.

  • f.

    MiTek Industries, Inc.; a subsidiary of Berkshire Hathaway Inc.

  • g.

    Robbins Engineering, Inc.

  • h.

    TEE-LOK Corporation; a subsidiary of Berkshire Hathaway Inc.

    • 1.

      Truswal Systems Corporation.

Fasteners: Where trusses are exposed to weather, in ground contact, or in area of high relative humidity, provide fasteners with hot-dip zinc coating complying with ASTM A 153/A 153M.

1. 2. 3. 4. 5.

Nails, Brads, and Staples: ASTM F 1667. Power-Driven Fasteners: NES NER-272. Wood Screws: ASME BI8.6.1. Lag Bolts: ASME B18.2.1 (ASME B18.2.3.8M).

Bolts:

Steel bolts complying

Class 4.6); washers.

with

ASTM A 563

with ASTM A 307, Grade A (ASTM A 563M) hex nuts

(ASTM F 568M, Property and, where indicated, flat

C.

Metal Truss Accessories: Provide truss accessories made from hot-dip, zinc-coated steel sheet complying with ASTM A 653/A 653M, G60 (ZI80) coating designation.

1.

Available Manufacturers:

Subject to compliance with requirements, manufacturers

2.

offering products that may be incorporated into the Work the following: Manufacturers: Subject to compliance with requirements, following:

include, but are not limited to,

provide products by one of the

SHOP-FABRICATED WOOD TRUSSES

061753-3

Document info
Document views856
Page views856
Page last viewedThu Dec 08 16:08:31 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments