X hits on this document

777 views

0 shares

0 downloads

0 comments

175 / 324

Mule-Hide Products

Fully Adhered TPO Single Ply Membrane

  • J.

    Arrange work sequence to avoid use of newly constructed roofing for storage, walking surfaces and equipment movement. Contractor shall provide all necessary protection and barriers to segregate the work areas and prevent damage to adjacent areas. If excessive traffic over newly installed membrane is necessary, contractor shall provide plywood, wood fiberboard or polyester felt protection to prevent damage. All damaged material shall be replaced with new materials.

  • K.

    All local building codes and requirements must be followed where applicable.

  • L.

    Both interior and exterior building areas affected by construction shall be cleaned up and any damaged areas shall be repaired to the owner's satisfaction.

  • M.

    When using heat-welding equipment, always review the equipment manufacturer's instructions, precautions and warnings.

1.06 Warranties

A.

Manufacturer's 1a-Year Standard System Warranty

A 1a-Year, "No Dollar Limit", labor and material warranty that covers the Manufacturer's labeled membrane and other components supplied by Manufacturer and installed by an Manufacturer's Warranty Eligible Applicator.

PART 2 - PRODUCTS

    • 2.01

      General

      • A.

        All components of the Fully Adhered TPO Membrane Roof System are to be either manufactured or approved by the Products Co., Inc, for the specified warranty.

2.02 Roofing Membrane

A.

TPO Membrane - 60-Mil TPO, polyester scrim reinforced roofing membrane that meets and exceeds the requirements of ASTM 06878 Standard Specification for Thermoplastic

Polyolefin Based Sheet Roofing.

Refer to

the

Product Data

Sheets for

physical

properties

and

additional

information.

2.03 Accessory Materials

A.

TPO Bonding Adhesive - A solvent-based rubberized adhesive that is used to bond the TPO Membrane to various vertical substrates and insulation boards. This Adhesive is a two-surface contact adhesive applied to both the underside of the membrane and substrate surface.

B.

Non-Reinforced TPO Flashing a non-reinforced, .060-inch thick material used where pre-molded accessories such as pipe boots and pre-molded corners cannot be used.

C.

Weathered Membrane Cleaner - a clear, liquid solvent, available in 5 gallon cans, used for cleaning asphalt and dirt from membrane surfaces.

  • D.

    TPO Prefabricated Flashings - TPO Universal Corners.

  • E.

    TPO Coated Metal- 24-gauge, galvanized steel to which is laminated 35 mils (.035" thick) of Mule-Hide TPO Non-Reinforced Flashing used for flashing and edge metal detailing.

F.

TPO .045 Reinforced 6" X 100'

is a .045 inch thick reinforced TPO Membrane strip

used for stripping-in TPO Coated Metal and as cover strips over TPO Coated Metal joints.

3

Document info
Document views777
Page views777
Page last viewedMon Dec 05 19:13:50 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments