X hits on this document

1376 views

0 shares

0 downloads

0 comments

194 / 324

PART 3

EXECUTION

3.01

MANUFACTURER'S INSTRUCTIONS

A. Compliance: Comply with manufacturer's product data, including product technical bulletins, product catalog installation instructions and product carton instructions for installation.

    • 3.02

      EXAMINATION

      • A.

        Site Verification of Conditions: Verify that substrate conditions, which have been previously installed under other sections, are acceptable for product installation in accordance with manufacturer's instructions.

        • 1.

          Verify that door frame openings are installed plumb, true and level before beginning installation process. Select fasteners of adequate type, number and quality to perform the intended functions.

    • 3.03

      PREPARATION

      • A.

        Surface Preparation:

    • 1.

      Preparation for Field Painting: Before application of finish coat of

paint, surfaces must be dry and free of dirt, oil and dust. Finish coat shall be applied over a film which is intact. Scratches or bare edges shall be field primed with a rust inhibiting paint before top coating. Comply with instructions on finish coat application provided by paint manufacturer.

3.04

INSTALLATION

A. General:

1.

2.

Set frame product plumb, square, aligned and without twist at correct elevation. Frame Installation: Install steel frames. Installation shall be plumb, straight and true, rigidly secured in place, and properly braced.

Comply with

Manufacturer's

installation

instuctions

and

AI\lSI/DHI

AllS-IG

installation

guide.

B.

Installation:

L 2,

3.

Secure anchorages and connections to adjacent construction. Install hardware in accordance with manufacturers' templates and instructions. Finish exposed field welds to present a smooth uniform surface.

Touch up with a rust inhibitive primer.

Section 3A

9

Document info
Document views1376
Page views1376
Page last viewedThu Jan 19 06:39:31 UTC 2017
Pages324
Paragraphs11037
Words86316

Comments