X hits on this document

835 views

0 shares

0 downloads

0 comments

195 / 324

4. Touch up exposed surfaces scratched or marred during shipment, installation or handling with a rust inhibitive primer. 5. Install glazing materials and compression weatherstrip.

C.

Installation Reference Standard(s): Install metal doors and frames in accordance with requirements of applicable reference standards.

1. Comply with Door and Hardware Institute (DHI) installation

2.

3.

standards. Comply with Steel Door Institute (SOl) maintenance standards. Comply with NFPA80 installation standards.

installation

and

E.

Related Products Installation: Refer to other sections listed under Related Sections for related products installation.

    • 3.06

      ADJUSTING

      • A.

        Adjusting: Adjust hinge sets, locksets and other hardware. Lubricate using a suitable lubricant compatible with door and frame coatings.

3.07

CLEANING

A.

Cleaning: Remove temporary coverings and protection of adjacent work areas. Repair or replace products that have been installed and

are damaged. manufactu rer's

Clean installed instructions prior

products to Owner's

in accordance with acceptance. Remove

construction

debris

from

project

site

and

legally

dispose

of debris.

Section 3A - 10

Document info
Document views835
Page views835
Page last viewedThu Dec 08 04:22:17 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments