X hits on this document

941 views

0 shares

0 downloads

0 comments

230 / 324

Section 09310

Part 2 PRODUCTS

    • 2.01

      CERAMIC TILE

      • A.

        Ceramic tile shall be 12 inch x 12 inch x 5/16 inch ceramic tile, "Ridgeview" Series as manufactured by Dal Tile, or equal, color to be selected. All accessory tiles shall be as required for a complete installation and shall include, but not be limited to:

        • a.

          Manufacturer's standard base, bull nose cap.

    • 2.02

      SETTING AND GROUTING MATERIALS

      • A.

        Setting mortar for ceramic and floor tile shall be POliland cement mortar conforming to ANSI A108.I. Joint grout shall be POliland cement grout conforming to ANSI Al 08.1.

      • B.

        Adhesive for ceramic wall tile cove base shall be Dry-Set adhesive, conforming to ANSI Al 08.5, applied over hardy backer or equal cementious backer units.

      • C.

        Grout coloring agent shall be added to permanently tint all grout to a color matching or complementing the adjacent surfaces. The Architect shall select the colors from the manufacturers standard range of colors.

      • D.

        Portland Cement: ASTM Cl50 Type1, Gray or White. Hydrated Lime: ASTM C206 or C207 Type S.

      • F.

        Sand: ASTM C144.

      • G.

        Water: Clean and drinkable.

      • H.

        Metal Lath: (as required)

        • a.

          Interior: Most uses - 2.5 lbs./s.y. galvanized. Metal Studs - 304 lbs/s.y. galvanized.

        • b.

          Exterior: Galvanized, 304 lbs/s.y.

      • I.

        Cementious backer units- Hardy backer or equal.

      • J.

        Shrinkage Mesh: 2" x 2" 16116.

      • K.

        Membrane: (as required)

        • a.

          Roofing Felt: ASTM AIIS.I, asphalt.

        • b.

          Polyethylene: ASTM CI71, 4 mil.

      • L.

        Dry-Set Mortars: ANSI AllSA

      • M.

        Latex Modified Dry-Set Mortars: ANSI Al18A

      • N.

        Organic Adhesives: ANSI A136.1 (Interiors)

        • a.

          For walls in shower areas, Type 1.

        • b.

          For floors - Type 1.

      • O.

        Epoxies:

        • a.

          Floor & Wall Adhesive: ANSI AlIS.3.

        • b.

          Heavy Duty & High Temperature Floor and Wall MOliar and Grout: ANSI AIl8.3.

Section 09310 2

Document info
Document views941
Page views941
Page last viewedSun Dec 11 02:30:27 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments