X hits on this document

930 views

0 shares

0 downloads

0 comments

233 / 324

Section 09510

ACOUSTICAL CEILINGS

Part 1- GENERAL

    • 1.01

      SCOPE OF WORK

      • A.

        The Contractor shall provide all labor, materials, tools and equipment required to furnish and install resilient tile flooring and vinyl base, as described in this section and as shown on the Contract Drawings.

        • 1.

          Suspended metal grid system complete with wall trim.

        • 2.

          Lay-in tegular acoustical ceiling boards.

    • 1.02

      SUBMITTALS

      • A.

        The Contractor shall provide descriptive submittals in accordance with the provisions of Section 01001 ofthese Specifications. Submittals include, but are not limited to, the following:

        • 1.

          Shop drawings showing all conditions where the suspended acoustical ceiling will interface with the work of other trades, details of all methods of suspension proposed to be used, layout of the grid system and all lateral restraint details.

        • 2.

          Manufacturers specification and catalog data needed to prove compliance with requirements of this section and the referenced documents.

        • 3.

          Samples of the color specified for the suspension system main runners, cross runners, edge trim and acoustical boards.

Part 2 - PRODUCTS

    • 2.01

      SUSPENSION SYSTEM

      • A.

        Manufacturers:

        • 1.

          Annstrong: Style 15/16 inch exposed Tee.

        • 2.

          Or approved equal.

      • B.

        Grid: Non-fire rated, exposed T configuration; components dies cut and interlocking.

      • C.

        Accessories: Stabilizer bars, clips, splices, edge moldings, as required for a secure, finished installation.

      • D.

        Grid Matetials: Commercial quality cold-rolled die cut, interlocking, electro galvanized steel.

      • E.

        Glid Finish: White, factory applied standard, white finish color. Wall trim finish and color shall match the grid finish.

      • F.

        Support Channels and Hangers: Galvanized steel, size and type as required to rigidly secure the ceiling system, including integral electIical and mechanical components, with a maximum deflection of 1/360 of the maximum room dimension.

Section 09510 1

Document info
Document views930
Page views930
Page last viewedSat Dec 10 20:34:04 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments