X hits on this document

698 views

0 shares

0 downloads

0 comments

238 / 324

Section 09900

    • 3.04

      FINISHING MECHANICAL AND ELECTRICAL EQUIPMENT

      • A.

        Refer to Division 15 and 16 for schedule of color-coding, identification banding or equipment, ductwork piping and conf1ict.

      • B.

        Color code items in accordance with requirements indicated. Color band and identify with f10w arrows names and numbering.

      • C.

        Paint shop primed equipment.

      • D.

        Remove unfinished louvers, grilles, covers and access panels and paint separately. Paint dampers exposed behind louvers, grilles, eonverter and baseboards cabinets to match face panels.

      • E.

        Prime and paint insulated and exposed pipes, insulated and exposed ducts, hangers, brackets, covers and supports, except where items are prefinished.

      • F.

        Paint exposed conduit and electrieal equipment occurring in finished areas except prefinished surfaces.

      • G.

        Paint both sides and edges of plywood backboards.

      • H.

        Reinstall electrical cover plates, hardware, light fixture trim, escutcheons and fittings removed prior to finishing.

    • 3.05

      SCHEDULE

      • A.

        Names and numbers such as ProMar or A-IOO are based on painting by Sherwin Williams.

      • B.

        Exterior Surfaces:

        • 1.

          Ferrous Metal

          • a.

            One coat red oxide primer (unless shop primed).

          • b.

            Two coats Metalastic II Enamel (alkyd gloss enamel)(2.0 mils)

        • 2.

          Galvanized Metal

          • a.

            One coat Galvite, B50 W 3 (acrylic primer)

          • b.

            Two coats Metalastic II enamel (alkyd gloss enamel)(2.0 mils)

        • 3.

          Concrete Masonry

          • a.

            One coat heavy duty bloek filler B42 W 46 acrylic resin block filler

(10.0 mils)

      • b.

        Two coats a-I 00 f1at Latex House and Trim latex paint (1.4 mils)

    • 4.

      Wood (Gloss)

      • a.

        One coat A-IOO Alkyd Exterior Wood Primer, Y24W20 (2.2 mils)

      • b.

        Two coats SWP Gloss House and Trim A2 Series (alkyd base) (2.0 mils)

    • 5.

      Wood (Transparent Finish)

      • a.

        As directed by Architect

  • C.

    Interior Surfaces:

    • 1.

      Gypsum Wallboard: Satin: Locations as directed.

      • a.

        One coat ProMar 200 Latex Wall Primer (vinyl acrylic latex primer) (1.4 mils)

      • b.

        Two coats ProMar Alkyd Egg-shell Enamel (soya alkyd enamel)(2.0 mils)

Gypsum Wallboard: Semi Gloss: Locations as directed. a. One coat ProMar 200 Latex Wall Primer (vinyl acrylic latex primer) (1.4 mils)

Section 09900 4

Document info
Document views698
Page views698
Page last viewedSat Dec 03 16:02:08 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments