X hits on this document

928 views

0 shares

0 downloads

0 comments

239 / 324

Section 09900

  • b.

    Two coats ProMar Alkyd Semi-Gloss Enamel (soya alkyd enamel)(2.0 mils)

    • 3.

      Plaster: Satin:

      • a.

        One coat ProMar 200 Alkyd Enamel Undercoater (interior alkyd primer)

(2.0 mils)

    • b.

      Two coats ProMar Alkyd Egg-shell Enamel (soya alkyd primer)(2.0 mils)

  • 4.

    Plaster: Semi-Gloss:

    • a.

      One coat ProMar 200 Alkyd Enamel Undercoater (interior alkyd primer)

(2.0 mils)

    • b.

      Two coats ProMar Alkyd Semi-Gloss Enamel (soya alkyd primer)(2.0 mils)

  • 5.

    Concrete Masonry Units Concrete: Satin:

    • a.

      One coat ProMar Filler (latex block filler)(10.0)

    • b.

      Two coats ProMar alkyd Egg-shell Enamel (soya alkyd enamel)(2.0 mils)

  • 6.

    Ferrous Metals

    • a.

      One coat red oxide metal primer (unless shop primed) (3.0 mils)

    • b.

      Two coats ProMar 200 Alkyd Semi-Gloss Enamel (soya alkyd enamel)(2.0 mils)

  • 7.

    Galvanized Metal:

    • a.

      One coat Calvite 850 W3 (acrylic primer) (2.0 mils)

    • b.

      Two coats ProMar 200 Alkyd Semi-Gloss Enamel (soya alkyd enamel)(2.0 mils)

  • 8.

    Interior Wood: Opaque Finish:

    • a.

      One coat ProMar 200 Alkyd Enamel Undercoater (interior alkyd primer)

(2.0 mils)

    • b.

      Two coats ProMar Alkyd Semi-Gloss Enamel (soya alkyd primer)(2.0 mils)

      • 9.

        Interior Wood: Transparent Finish:

        • a.

          One coat satin (if required by Architect)

    • b.

      One coat oil base gloss varnish (1.0 mils)

        • c.

          One coat oil base satin vanish (1.0 mils)

      • 3.06

        CLEAN-UP

  • A.

    The Contractor shall do elean up as follows:

    • a.

      Place cloths, cotton waste and other debris that might constitute a fire hazard, in closed metal containers and remove at the end of each day.

    • b.

      Remove from the site all staging, scaffolding and containers and leave the entire jobsite clean.

  • A.

    Remove coatings and other deposits from adjacent surfaces. As work proceeds, promptly remove paint where spilled, splashed or spattered.

END OF SECTION

Section 09900 5

Document info
Document views928
Page views928
Page last viewedSat Dec 10 17:12:12 UTC 2016
Pages324
Paragraphs11037
Words86316

Comments