X hits on this document

150 views

0 shares

0 downloads

0 comments

34 / 69

For cold adhesive application, use the mop and flop method and back mop all side and end laps. Roll all side and end laps with a seam roller upon completion of the work. (*Or substitute appropriate SBS modified bitumen adhesive as described on page 30).

Flashing Details: Flintlastic SBS Modified Bitumen

Flashing details are accomplished using cut pieces of Flintlastic SBS modified bitumen (base flashing and counterflashing strips), sometimes in combination with appropriate prefabricated flashing components.

The flashing and counterflashing membrane are set in either hot asphalt or appropriate SBS modified bitumen elastomeric flashing cement, or torch applied. The same side and endlap rules apply to flashing details as to field membrane. Examples of typical flashing details are as follows:

Shingle Roof Transition Existing shingles must be removed and replaced to accommodate this detail. At transitions from a “flat” roof section to a sloped, shingle roof section the completed Flintlastic SBS modified bitumen roof system must extend a min. of 18" up the sloped section, past the transition point. (Note that the base sheet must first be installed, extending up the sloped

Shingle roof transition

32

Document info
Document views150
Page views150
Page last viewedMon Dec 05 07:55:54 UTC 2016
Pages69
Paragraphs1412
Words15077

Comments