X hits on this document

544 views

0 shares

0 downloads

0 comments

10 / 201

8

Printer

NOTE

The UP-700 may be configured with multiple types of printers offered by the market. For specific instructions related to the handling and care of the printer, please refer to the applicable printer instruction manual.

The printer is a receipt/journal dual station type thermal printer, and therefore it does not require any type of ink ribbon or cartridge. The average life of the printer is approximately 5 million lines.

Printer cover

Printer lock key

When opening the printer cover, unlock the printer cover using the printer cover lock key, and lift up the cover as shown on the right sketch.

Your register is shipped with the print head release lever held by a white retainer in the lifted up position. Be sure to remove this retainer (see the figure at the right) and push down the print head release lever before you use the POS terminal.

Retainer

Print head release lever The print head can be lifted by the green lever on the right side of the printer. Pulling the lever forward lifts the print head up. If the paper becomes jammed and you need to move the head farther forward, you can pull the lever even further toward you and proceed with the removal of the jammed paper.

Paper roll location

Take-up spool

Paper chute

Print head release lever

NOTE

Do not attempt to remove the paper roll with the head in the down position. This may result in damage to the printer and print head.

Document info
Document views544
Page views545
Page last viewedThu Dec 08 10:44:00 UTC 2016
Pages201
Paragraphs7587
Words43074

Comments