X hits on this document

588 views

0 shares

0 downloads

0 comments

122 / 201

120

PLU range

You can make a recipe table which contains up to ten ingredients.

Procedure

Enter a value or select an option for each item as follows:

  • START (Use the numeric entry) Starting PLU code (max. 5 digits)

  • END (Use the numeric entry) Ending PLU code (max. 5 digits)

  • OPERATION (Use the selective entry)

MAINTE.:

Enables you to change the setting you have programmed.

NEW&MAINTE.:

DELETE:

Enables you to change the current setting when the specified codes have already been created or to create new codes when the specified codes have not been created yet. Enables you to delete a specified range of PLUs.

The screen continues in the same format as those screens shown in section “PLU/EAN”.

PLU/EAN stock

You can assign a stock quantity to each PLU/EAN code. Shown below is an example of selecting “1 OVER WRITE.”

Procedure

After selecting “1 OVER WRITE,” select a pertinent PLU/EAN code. Then the next screen will appear to show the following items:

  • CURRENT ST The current stock is displayed.

  • NEW STOCK (Use the numeric entry) Enter a new stock quantity (max. 7 digits: 1 to 9999.999(9999999))

Select a pertinent PLU code, or directly enter a PLU code or EAN code.

NOTE

  • If you need to add or subtract a stock quantity to or from the current stock quantity, select “2 ADD” or “3 SUB” and enter a value to be added or subtracted.

  • You cannot enter any values for the item marked with “!”.

  • The entry of a new stock value will update to the PLU/EAN stock counter.

Document info
Document views588
Page views589
Page last viewedSun Dec 11 01:05:24 UTC 2016
Pages201
Paragraphs7587
Words43074

Comments