X hits on this document





189 / 201

Setting the date and time when the automatic EURO modification operation should be executed To certainly execute the automatic modification operation, you can program the scheduled date and time to execute the automatic EURO modification operation. From ten days before the preset date, the remaining days are printed at the bottom of the daily full resetting report.

Date and time setting will be reset after the execution of automatic modification operation, and again you can program the date and time for the next automatic modification operation.

Also you can make the automatic EURO modification operation compulsory. When the above-mentioned preset date and time has come, and also when you start an entry in the REG/MGR mode, the error message “EURO CHANGE ENTRY COMPULSORY” will be displayed. You cannot start any operation in the REG/MGR mode until you make the operation.

Automatic EURO modification operation

  • 1.

    Move the mode key to the X2/Z2 position.

  • 2.

    Select “8 EURO STATUS” from the menu.

  • 3.

    Select the status you want to set (B, C or D) referring to the table above. Press the

the options. Please note that once you set a status, you cannot return to the previous status(es).

. key to toggle

Important note As for the miscellaneous keys, such as

J and

) keys, and for the HALO setting, the automatic

conversion will not be made. You need to change the % rates or amounts in the PGM1/PGM2 mode after the execution of the automatic modification operation for EURO so that they are based on amounts in EURO.


It is executed some of following operation which is needed for each status. (1) Issue general Z1 report. (2) Issue general Z2 report. (3) Clear GT1/GT2/GT3. (4) Change PGM function “Total and change amount printing — With foreign/Domestic only”. (5) Change PGM function “Exchange1 amount printing for total validation print — YES/NO” and “Total validation print amount printing — With foreign/Domestic only”. (6) Change PGM function “Exchange1 calculation method — Division/Multiplication”. (9) Change PGM function “Converting the preset unit prices of departments/PLUs/EANs to the ones in EURO currency - YES/NO. (10) Set “Exchange1 currency descriptor” as the suitable data. (11) Set “Exchange1 TAB as the suitable


This job cannot set the following additional EURO function. You must set the following items by each programming after executing the automatic EURO modification operation.

(1) Exchange1 rate, (2) “Check, Credit operation for Exchange1 — YES/NO” (3) Foreign currency drawer number (if installed) Also when you are using any of the < through + keys, you must change these rates.


Document info
Document views324
Page views324
Page last viewedTue Oct 25 17:44:55 UTC 2016