X hits on this document

890 views

0 shares

0 downloads

0 comments

192 / 201

190

Installing and Removing the Paper Roll

Recording paper specifications

Be sure to use paper rolls specified by SHARP. T h e u s e o f a n y o t h e r p a p e r r o l l s t h a n s p e c i f i e d c o u l d c a u s e p a p e r j a m m i n g , r e s u l t i n g i n P O S t e r m i n a l

malfunction.

Paper specification Paper width:

57.5 ± 0.5 mm

Max. outside diameter: 80 mm

Quality:

Thermal paper

Paper tube:

18 mm

  • Be sure to set paper roll(s) prior to using your machine, otherwise it may cause a malfunction.

Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.

NOTE

If the top end of the paper roll is fixed with paste or tape, the paper may lose its color development ability in the pasted or taped area due to the deterioration of the heat-sensitive color development component of the paper surface. This may result in nothing appearing at this location when printing is performed. Therefore, when setting a new paper roll in the machine, be sure to cut off approximately one revolution (approx. 25 cm long).

(How to set the paper roll)

(How to cut the paper end)

To the printer

To the printer

Incorrect

Correct

Correct

Incorrect

Installing the paper roll

Installing the receipt paper roll

Printing position

  • 1.

    Turn the mode switch to the “REG” position with the AC cord connected and the power switch “ON”.

  • 2.

    Remove the printer cover.

  • 3.

    Check that the print head release lever is in its printing position.

  • 4.

    Set the paper correctly as illustrated above in the receipt side of the printer.

  • 5.

    Insert the end of the paper into the paper chute as shown on the left. It will automatically be fed through the printer.

  • 6.

    Cut off the excess paper that comes out of the printer with the manual cutter.

  • 7.

    Replace the printer cover.

Document info
Document views890
Page views891
Page last viewedWed Jan 18 06:43:19 UTC 2017
Pages201
Paragraphs7587
Words43074

Comments