X hits on this document

427 views

0 shares

0 downloads

0 comments

71 / 201

TRAINING Mode

The training mode is used when the operator or the manager practices POS terminal operations.

NOTE

In case “clerk and cashier system” is applied to your POS terminal, cashiers can enter to the training mode.

When a clerk/cashier set in training is selected, the POS terminal automatically enters the training mode, while a clerk/cashier not set in training is selected, the POS terminal automatically enters the ordinary REG mode. A training text and a maximum of two training clerks/cashiers can be programmed. For programming of training clerk/cashier, contact your authorized SHARP dealer.

The training operations are valid in all modes. A mark which is identifying a training receipt is printed on the receipt which is issued in the training mode.

The journal report completely stops in the training mode. The consecutive number is not updated. The preceding number is repeated in printing.

The memory in clerk/cashier is updated in the training mode. Other memories are not updated.

The GLU codes which are opened in the training mode are also printed on the GLU report. In this case, those GLU codes are distinguished from others by the character of “T.” The data of training GLU codes are not added to the total.

Selecting the

5

clerk set in

3x

training

3

c

The reading and resetting of training clerks/cashiers is printed on the clerk/cashier reports. However, the sales total of training clerks/cashiers is not included in the clerk/cashier total on the full clerk/cashier report.

Key operation

Print

69

Document info
Document views427
Page views428
Page last viewedFri Dec 02 22:22:35 UTC 2016
Pages201
Paragraphs7587
Words43074

Comments