X hits on this document

22 views

0 shares

0 downloads

0 comments

2 / 6

  • 5.

    EQUIPMENT

    • 5.1

      Torque Wrench. Use a Snap-On Model TER12FUA Torque Wrench, or equivalent to measure the static torque of the rotatable adaptor.

5.2

Static Torque Test Assembly. Use a compatible dust cap and rotatable adaptor Torque Test Tool, Phil-Tite® Part Number 6004 or equivalent. A depiction is shown in Figure 1. An example of a Static Torque Test Assembly is shown in Figure 2.

Figure 1 Phil-Tite® Torque Test Tool

    • 5.3

      Socket wrench and socket extension. Use a 3/8 inch or ½ inch socket wrench, adaptors and socket extension (if needed) to verify 360-degree rotation or to conduct static torque testing. The socket extension shall not exceed 12 inches in length.

    • 5.4

      Traffic Cones. Use traffic cones to encircle the Phase I area while the test is being conducted.

OPW Fueling Components - Phase I Vapor Recovery System – VR-102-A

Document info
Document views22
Page views22
Page last viewedThu Dec 08 01:10:37 UTC 2016
Pages6
Paragraphs194
Words1235

Comments