X hits on this document

22 views

0 shares

0 downloads

0 comments

4 / 4

To re-order, call 800.545.6566

Safety Features

  • Durable Teflon® handpiece has phenolic insulators to protect your hands from heat.

  • Three-second timer cuts off heat automatically—even when foot pedal is depressed.

  • “Re-cirk-it”switch on the back of the machine recirculates power to the machine if it overheats.

  • Hot Spot produces little or no noise and releases little or no harmful fumes when using liquid flux

and solder-filled jump rings.

Maintenance

Keep the graphite electrodes and plier tips free from carbon buildup.Wipe plier tips with a clean,soft cloth or clean them with a fine-grade sanding stick. For the most efficient soldering,use an electrode sharpener (available below) to reshape the electrode whenever it becomes rough or worn.

Troubleshooting

The Hot Spot® Jump Ring Soldering Machine is relatively easy to use;however,if you should encounter any difficulties,the table below offers some solutions.Please call our technical support staff at 1-800- 545-6566 if you require more information.

Issue

Possible Cause

Solutions

Electrode is worn

Overuse;too much pressure applied; poor contact with piece

Use the opposite end of the electrode;reshape the electrode using the sharpener or fine-grain sandpaper; replace the electrode.

Machine is overheated

Too much power going through

Ensure that you are using a 115V AC outlet,or press the “Re-cirk-it”button on the back of the machine.

Loose connection to power source

Tighten the handpiece connection.

Exposed to heat too long;too much pressure applied to jump ring;operator touched electrode to jump ring after activating power with the foot pedal

Reduce the heating time and/or pressure;touch elec- trode to jump ring before pressing the foot pedal.

Heat is not conducting through the collet

Jump rings are melting

Metal sparks and burns

Too much power or poor electrode contact on the metal Clean and reshape the electrode;clean plier tips;

surface

reduce power setting/adjust dwell time downward;

ensure that the electrode does not contact any flux.

Description

Order #

Replacement electrodes, pkg/3

503-133/3

Electrode sharpener

503-129

Replacement Teflon® Handle

503-134

Needle-nose pliers accessory

503-189

4

To re-order, call 800.545.6566

jump-ring assortment ;pkg/150* *Assortment contains 20-gauge jump rings—50 each in sizes 3/32",1/8" and 5/32".

©2009 The Bell Group,Inc. All rights reserved. RGIS 503-124 05/09KG

Electro flux

504-074

Sterling solder-filled

693-406

Document info
Document views22
Page views22
Page last viewedTue Dec 06 17:22:43 UTC 2016
Pages4
Paragraphs164
Words1402

Comments