X hits on this document

25 views

0 shares

0 downloads

0 comments

8 / 12

Bar charts

You use the BarChart control to represent data as a series of horizontal bars whose length is determined by values in the data. You can use the BarChart control to represent a variety of chart variations, including clustered bars, overlaid stacked, 100% stacked, and high-low areas.

Bubble charts

You use the BubbleChart control to represent data with three values for each data point: a value that determines its position along the x-axis, a value that determines its position along the y-axis, and a value that determines the size of the chart symbol, relative to the other data points on the chart.

The <mx:BubbleChart> tag takes an additional property, maxRadius. This property specifies the maximum radius of the largest chart element, in pixels. The data point with the largest value is assigned this radius; all other data points are assigned a smaller radius based on their value relative to the largest value. The default value is 30 pixels.

The following figure shows an example of a bubble chart:

METAOPTION LLC, 574 NEWARK AVENUE, SUITE 210 JERSEY CITY, NJ 07306; PH: 201-377-3150 EMAIL: info@metaoption.com: WEB SITE: www.metaoption.com

Document info
Document views25
Page views25
Page last viewedSun Dec 04 03:55:24 UTC 2016
Pages12
Paragraphs123
Words3180

Comments