X hits on this document

90 views

0 shares

0 downloads

0 comments

5 / 21

Assembly and Set-up instructions

NOTE: the drum shown below is not supplied in the kit, any empty drum can be used for mixing the chemical solution, please make sure it has been cleaned in advance!

  • Connect the 5m air supply hose(4) to the 1040 pump(1) and to the air distributor(2)

  • Connect the suction hose(5) to the inlet of the pump(1) and place the other end in a suitable container or a drum

  • Connect the Inlet(7) and Nozzle section(8) of the lance

  • Fit either the Foam(9), Standard(10) or SlipCoat(11) nozzle to the Lance nozzle section(8).

  • Connect the ¾” chemical delivery hose(6) to the Lance inlet section(7) and to outlet of the chemical pump(1)

  • Connect ” air supply hose(3) to the Lance inlet section(7) and the air distributor(2).

Nozzle selection

9-

10 -

11 -

Foam nozzle: for cleaning chemicals with foaming properties – generates thick foam. Standard nozzle: for all other cleaning chemicals – extends the reach of the spray with out foaming. The Standard nozzle can also be used for washing down if needed. SlipCoat nozzle: for temporary hold coatings – thin and even spray but a very short range, (the Standard nozzle can be used for longer reach)

Revision date: 04/2008

Page 5 of 21

Document info
Document views90
Page views99
Page last viewedFri Dec 02 22:49:28 UTC 2016
Pages21
Paragraphs622
Words6036

Comments