X hits on this document

Word document

Improved Low Voltage Detection Warning: - page 2 / 6

13 views

0 shares

0 downloads

0 comments

2 / 6

Computer Radio Progamming Examples:

Airtronics Stylus with PCM receiver (p/n 92185):

Plug the Lost Model Locator in channel #8 (GEAR) of the receiver.

Scroll to the Modulation menu (MOD) and select PCM.

You need to temporarily assign a switch to the GEAR function so that you can edit the respective values in that menu. Scroll to the Switch menu (SW), then scroll to GEAR and assign switch #11.  Before leaving, flip the ALT switch immediately above the throttle/flap stick and verify that the switches status changes from OFF (down) to ON (up).

Scroll to the GEAR menu.  With the ALT switch UP, the display should show GEAR-1. Enter 150%.  Flip the ALT switch down and the display should show GEAR-2.  Enter –150 (negative 150%).

Scroll to the Fail-Safe menu (F-SAFE) and inside that menu, scroll to GEAR (GE).  With the ALT switch in the down position, press the YES/+ key and the display should show –150%.

With the transmitter powered up and the ALT switch in the UP position, power up the receiver.  After the LML beeps the number of cells in the battery pack, power down the Stylus transmitter and the LML should sound the lost model tone.  Power the Stylus back up and the lost model tone should stop.

If you flip the ALT switch to the DOWN position the lost model tone will sound.  If you are using the ALT switch for other functions or do not wish to have the switch trigger the lost model tone, then scroll to the switch menu (SW) and clear the switch assignment for GEAR to 0.

Airtronics Stylus with PPM receiver and switch activated lost tone:

Plug the Lost Model Locator in channel #8 (GEAR) of the receiver.

Scroll to the Modulation menu (MOD) and select PPM or PPM-INV, whichever is appropriate for the receiver that you are using.

You need to assign a switch to the GEAR function so that you can edit the respective values in that menu.  This switch will also activate the lost model tone.  Scroll to the Switch menu (SW), then scroll to GEAR and assign switch #11.  Before leaving, flip the ALT switch immediately above the throttle/flap stick and verify that the switches status changes from OFF (down) to ON (up).

Scroll to the GEAR menu.  With the ALT switch UP, the display should show GEAR-1. Enter 150%.  Flip the ALT switch down and the display should show GEAR-2.  Enter –150 (negative 150%).

With the transmitter powered up and the ALT switch in the UP position, power up the receiver.  After the LML beeps the number of cells in the battery pack, power down the

Document info
Document views13
Page views13
Page last viewedSat Dec 10 06:34:28 UTC 2016
Pages6
Paragraphs88
Words2274

Comments