X hits on this document

Word document

Improved Low Voltage Detection Warning: - page 4 / 6

10 views

0 shares

0 downloads

0 comments

4 / 6

direction OR you can go to the GEAR Travel menus and enter transpose the travel values between Gear TV1 and Gear TV2.

With the switch in the position that enables the lost model tone, scroll to the CONFIG column then down to ENABLE FS?.  Respond “YES”.  Scroll down to the next item, SEND FS?.  Press “<-ENT” and “ENT->” at the same time.  The lost model tone will sound when the transmitter is powered OFF.

Airtronics Vision with PPM receiver and switch activated lost tone:

Plug the Lost Model Locator into the channel designated for GEAR control as detailed in the operator’s manual.

Scroll to the Modulation menu (MOD) and select the appropriate receiver modulation as detailed in the operator’s manual.

You need to enable the gear switch, which is the top, right, forward toggle switch.  Scroll to the CONFIG column then down to Gear Mode? And press INC so that the display shows “YES”.  Scroll to the SURFACE column.  Scroll down to the Gear Travel (GEAR TV1) menu and enter 100%.  Scroll down to the next Gear Travel (GEAR TV2) menu and enter –75%.

With the transmitter powered up and the GEAR switch pressed away from you, power up the receiver.  After the LML beeps the number of cells in the battery pack, flip the GEAR switch toward you and the lost model tone will sound.  If you prefer the opposite switch direction, either you can go to the Reverse menu under CONFIG and flip the GEAR channel direction OR you can go to the GEAR Travel menus and enter transpose the travel values between Gear TV1 and Gear TV2.

JR-XP8103 with PCM receiver and switch activated lost tone:

Plug the Lost Model Locator into the GEAR channel #5 (ACRO mode) as designated for GEAR control and detailed in the operator’s manual.

Scroll to the Modulation menu (MOD) and select Z-PCM modulation or as appropriate as detailed in the operator’s manual.

Scroll to the Travel Adjust menu (TRVL ADJ) and move to the Gear travels. Set the top value to +100%.  Flip the gear switch (top, front, left switch) to its opposite direction, and set the lower Gear travel to –150%.

With the transmitter powered up, power up the receiver.  After the LML beeps the number of cells in the battery pack, flip the GEAR switch and the lost model tone will sound.  If you prefer the opposite switch direction, either you can go to the Reverse menu and reverse the GEAR channel direction OR you can go to the GEAR Travel menus and enter transpose the travel values.

With the switch in the position that enables the lost model tone, scroll to the Fail Safe screen.  Press the “L/+” key until 1.0 sec is displayed.  Next press the CLEAR key to send

Document info
Document views10
Page views10
Page last viewedMon Dec 05 17:02:51 UTC 2016
Pages6
Paragraphs88
Words2274

Comments