X hits on this document

PDF document

CD3, 3 PIN DEUTSCH MATING CONNECTOR, - page 2 / 2

4 views

0 shares

0 downloads

0 comments

2 / 2

MC-CD3

DEUTSCH DT SERIES 3 PIN MATING CONNECTOR W/BOOT

  • -

    MATES TO DEUTSCH DT04-3P w/size 16 pins

CONNECTOR ASSEMBLY INSTRUCTIONS

1.) Grasp crimped contact approximately 1 “ (25.4mm) behind the contact barrel

2.) Hold connector with rear grommet facing you.

3.)

Push contact straight into

connector grommet until a click

is felt. A slight tug will confirm that it is properly locked in place.

4.) Once all contacts are in place insert orange or green wedge. If there is an arrow, point it towards the locking mecha- nism. Rectangular wedges are not oriented.

NOTE: The receptacle (CD3) is shown. Process is the same for the plug(MC-CD3).

CONTACT REMOVAL INSTRUCTIONS

1.) Remove wedge using needlenose pliers or a hook shaped wire to pull wedge straight out.

2.) To remove the contacts gently pull the wire backwards while at the same time releasing the locking finger by moving it away from the contact with a screwdriver.

3.) Hold the rear seal in place as removing the contact will displace the seal.

Sensor Solutions Corp.

  • V: (970) 879-9900

F: (970) 879-9700

  • www.sensorso.com

  • Rev. A

Document info
Document views4
Page views4
Page last viewedMon Oct 24 22:56:44 UTC 2016
Pages2
Paragraphs71
Words314

Comments