X hits on this document

PDF document

Remote Car Starter Installation Manual for Model 40027, 40027T - page 1 / 20

62 views

0 shares

0 downloads

0 comments

1 / 20

Remote Car Starter Installation Manual for Model 40027, 40027T

www.designtech-intl.com www.directed.com 800-876-0800

PLEASE READ COMPLETELY BEFORE BEGINNING

Congratulations on your purchase of the AutoCommand® Remote Car Starter. AutoCommand® Remote Car Starter allows you to start the car by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.

AutoCommand® is for automatic transmission, fuel injected gasoline vehicles only. Please see pages 6-7 for important information about vehicles with factory anti-theft systems. AutoCommand® is an extremely sophisticated system with multiple built-in safety and security features.

AutoCommand® Remote Car Starter:

Will start your car by remote control, and run the heater, defroster, or air conditioner to warm up or cool down the car. Is designed to start the car if it is in park, and only if the hood is closed. Has Lock, Unlock and Trunk Pop keyless entry features. Will attempt to start the car for up to six seconds, but no longer (to avoid damage to the starter motor). Should the car not start, or if it stalls after starting, the remote starter will make two further attempts to start it.

Will not let the car be driven without the key in the ignition. Shuts itself off automatically after 10 or 15 minutes (programmable) if you forget to come out to your car. Will shut off if the brake pedal is pushed, the hood is opened, or the transmission is shifted out of park - unless the key is in the ignition and in the “run” position. Protects your vehicle with a basic alarm system. Is quality engineered and microprocessor controlled to provide many years of reliable use.

Tools required to install the AutoCommand® Unit:

Wire Cutters/Strippers

Electrical Tape

Soldering Iron

Screwdriver

Pliers

Drill with 1/4”and 5/16drill bits

Comes with a Limited Lifetime Warranty.

Circuit

Color

Function

Type

Pink

Power (+12V)

Input

White

Accessory

Relay output

Ye l l o w

Starter

Relay output

Blue

Ignition 1

Relay output

Green

Ignition 2

Relay output

Black

Ground

Input

Small Yellow

HeaLights

Relayoutput

Required Yes Yes Yes Yes Consult Wiring Guide* Yes Optional

Power Harness

Wiring Diagram

Testmeter

Color

Function

Circuit Type

Required

Green Brown/White

Tach Alarm Disarm

(-) Input (–) 400 mA Output

No Consult Wiring Guide*

White/Black Green/White Yellow/Red

IGN 3 Trunk Lock

(–) 400 mA Output (-) 400 mA Output (+/-) 400 mA Output

Consult Wiring Guide* No No

Coax Antenna Jack

We highly recommend that all connections be soldered for reliability. P a r t s L i s t i n c l u d e d w i t h t h e A u t o C o m m a n d ® U n i t :

Remote Starter Receiver Module Transmitter Antenna with Custom Clip Control Harness (6 position) Keyless Entry Harness (4 position) 6 Power & Ignition Wires Yellow Headlight Wire

ON/OFF Switch Jack

Control Harness

Color

Function

Circuit Type

Required

White/Red

Unlock

(+/-) 400 mA Output

No

Gray/Black

Alarm Input

(-)

Input

No

Purple

Hood Switch

(-)

Input

Yes

Orange

Brake

(+)

Input

Yes

Blue

Horn

(-) 400mA Output

No

v5.3 (40027)

The following parts are included in the plastic bag:

lchohol Pad

Alcohol Pad Ring Terminal

Green 30 A Fuse On/Off Control Switch

Hood Pin Switch Set

Warning Label

2 Cable Ties

2 Protected by DesignTech Labels

Yellow Butt Connector

  • *

    For free vehicle specific wire information, consult

our website at www.designtech-intl.com

1

© 2005 Directed Electronics, Inc.

Document info
Document views62
Page views62
Page last viewedMon Dec 05 06:39:45 UTC 2016
Pages20
Paragraphs1310
Words20000

Comments