X hits on this document

PDF document

Remote Car Starter Installation Manual for Model 40027, 40027T - page 9 / 20

91 views

0 shares

0 downloads

0 comments

9 / 20

© 2005 Directed Electronics, Inc.

Pushing the Control switch off (LED turns Green) puts you in Valet Mode. In Valet Mode, the Remote Car Starter and the alarm will not function. This lets you turn off the car starter when having the vehicle serviced. The only functions that work in Valet Mode are the keyless entry, lights and panic. Simply push the Control switch once again (LED turns Red) to exit Valet Mode.

Valet Mode:

If the doors are locked, the alarm is set, and you’ve lost your transmitter, you can still disable the alarm. Here is how: Enter the vehicle (alarm will sound) and insert the key and turn it to the ‘run’ position (the position where the instruments and gauges turn on). Push and release the On/Off switch Off and On 8 times in a row to disable the alarm.

battery (CR 2032 style). The transmitter and receiver are FCC and DOC approved. To Disarm the Alarm without the Transmitter:

lights button, and Green for the

lock and

, unlock buttons. The transmitter is powered by a long life lithium

The LED on the transmitter will display 3 different colors - Red for the

start button Yellow for the

Button

Once: Unlock the door / disarm the alarm Hold down for 4 seconds to open the Trunk. (If you get 4 chirps – that means the alarm was triggered while you were away)

Button

Once: Lock the door / arm the alarm

IMPORTANT NOTE: This product warranty is automatically void if its date code or serial number is defaced, missing, or altered. Make sure you have all of the following information from your dealer: A clear copy of the sales receipt, showing the following: Date of purchase Authorized dealer’s company name and address Item number

LIMITATION OF DAMAGES AND LIABILITY. CONSUMER’S REMEDY IS LIMITEDTO REPAIR OR REPLACEMENT OF THE UNIT, AND IN NO EVENT SHALL DIRECTED’S LIABILITY EXCEED THE PURCHASE PRICE OF THE UNIT. IN ANY EVENT, DIRECTED SHALL NOT BE LIABLE FOR ANY DAMAGES INCLUDING, BUT NOT LIMITEDTO, ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, PUNITIVE OR CONSEQUENTIAL DAMAGES, LOST PROFITS, LOST SAVINGS, OR, TO THE EXTENT ALLOWED BY APPLICABLE LAW, DAMAGES RESULTING FROM DEATH OR INJURY ARISING OUT OF OR IN CONNECTION WITH THE INSTALLATION, USE, IMPROPER USE, OR INABILITY TO USE, THE PRODUCT, EVEN IF THE PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OF LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSION MAY NOT APPLYTO YOU.THE CONSUMER AGREES AND CONSENTSTHAT ALL DISPUTES BETWEEN THE CONSUMER AND DIRECTED SHALL BE RESOLVED IN ACCORDANCE WITH CALIFORNIA LAWS IN SAN DIEGO COUNTY, CALIFORNIA.

Button:

Button:

Button:

Do not push for your first ‘main’ vehicle Once: To operate vehicle #2 - then any of the 4 buttons (LED flashes red and green) Again: For vehicle #3 - then any of the 4 buttons (LED flashes red) Again: For vehicle #4 - then any of the 4 buttons (LED flashes green) Once: Start the car with all accessories left on Again: Stop the car Once: Turn on headlights for 30 seconds Again: Turn off headlights Hold down for 4 seconds for PANIC mode (45 seconds long)

THE FOREGOING WARRANTY IS THE EXCLUSIVE PRODUCT WARRANTY, OTHERWISE, ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY EXCLUDED AND DISCLAIMED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. DIRECTED HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. SOME STATES DO NOT ALLOW THE LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.

If all features are installed, your transmitter will function as follows:

The AutoCommand Remote Car Starter has numerous safety and security features that make it difficult to steal your car without the key being in the ignition. Putting your car in gear, pushing the brake pedal or opening the hood will turn the unit off unless your key is in the ignition and turned to the “run” or “on” position.

®

The AutoCommand Remote Car Starter will turn the car off if the driver does not insert and turn the key within 10 or 15 minutes. After the AutoCommand Remote Car Starter has started your car, simply put in the key and turn it to the “run” or “on” ignition position (not the crank position), push the brake pedal and drive away.

®

®

The Remote Car Starter must be “enabled” each time the driver has finished driving and taken out the key in order for the unit to start the vehicle remotely. After the key has been removed, you must push the control switch OFF (LED turns Green) and then push it back ON (LED turns Red) again while no key is in the ignition. The LED will glow red signifying the system is ready to start. This “control switch” or “set switch” prevents unauthorized starting of the car by someone unfamiliar with the system who may be using the vehicle. If you forget to set the switch, it may also be activated by pushing the transmitter and holding the button down for seven seconds. To eliminate the need for this, see Option #7 (Setting Program Features).

Directed Electronics, Inc. (hereinafter “Directed”) promises to the original purchaser to repair or replace with a comparable reconditioned Directed DIY remote start keyless entry unit if this Directed DIY remote start keyless entry unit (hereinafter “Unit”), excluding without limitation, any remote transmitters or associated accessories, proves defective in materials or workmanship under normal use for the life of the vehicle which the Unit is originally installed. During this period, so long as the Unit remained installed in the original vehicle, Directed will at its option, repair or replace this Unit if it is proved defective in workmanship or material PROVIDED the Unit is returned to Directed’s warranty department at One Viper Wa , Vista, CA 92081, along with $20 postage and handling fee, a bill of sale or other dated proof of purchase bearing the following information: Date of purchase, name and location of the merchant who sold the Unit, and product description. This warranty does not cover labor costs for the removal or reinstallation of the Unit. This warranty is non-transferable and does not apply to any Unit that has been modified or used in a manner contrary to its intended purpose, and this warranty does not cover damage to any Unit caused by installation or removal of the Unit. This warranty is void if the Unit has been damaged by accident or unreasonable use, neglect, improper service or other causes not arising out of defects in materials or workmanship. Directed makes no warranty against theft of a vehicle or its contents.

USER TIPS AND NOTES

v5.3

limited lifetime consumer warranty

Document info
Document views91
Page views91
Page last viewedMon Jan 23 05:17:03 UTC 2017
Pages20
Paragraphs1310
Words20000

Comments