Part Number 120 Volts
Part Number 240 Volts
3.152 4.236 6.354 1004 (4 Cyl) A & B
1006 (6 Cyl) A & B
1104 (4 Cyl) C
700 Series 704.30
D12C Prior to Serial # 250502
D12C After Serial # 250502
Mounts below turbo charger on right center of engine
Mounts in freeze plug
Mounts in the "football shaped" plate on the front,right side of the engine
Mounts in 1 1/4”freeze plug opening on right rear of engine with element straight up in 12 O’clock position
Mounts in freeze plug in rear of head
Mounts in the 1 1/2”freeze plug on the right side of the engine
Mounts in the 1 1/4”freeze plug opening on the right side of the engine
Direct Immersion Heaters
Note: In-block heaters are complete with 2-wire w/ground 6 foot HPN cord and plug. For cord replacements or “Y” thermocord energy saver, please reference page 12.
TD60,TD61,TD70, TD71,TD100,TD101, VE10,TD120,TD121
3T72HLE 4TN82E D4T YYDXL4.41
Mounts into threaded opening (44mm) in the front of the engine
1” NPT No replacement cord available
NOTE:The only replacement parts for the direct immersion heaters is the power cord. Please see the power cord section on page 12 for the proper replacement cord set.
For thermostat control of in-block direct immersion heaters see page 12.The energy saver Thermocord is available in various temperature ranges.
Supplemental heat for engines using in-block direct immersion heaters can be acquired by the installation of oil pan heaters in the lube-oil. Reference page 18 of this catalog or consult factory.
If supplemental oil heating is desired, this column gives the correct thread size in oil pan. See NOTE on page 11.
Customer Support: (509) 536-8660
Toll-Free FAX: (800) 224-5550