X hits on this document

91 views

0 shares

0 downloads

0 comments

6 / 24

In-Block

Direct Immersion Heaters

Note: In-block heaters are complete with 2-wire w/ground 6 foot HPN cord and plug. For cord replacements or “Y” thermocord energy saver, please reference page 12.

3456 15.8L

AC-101

AC-102

1000

CATV-151

CATV-152

1500

Engine Model

Replaces 1”thread-in plug in the rear of the oil cooler bonnet on the right side of the engine

Part Number 120 Volts

Caterpillar — Continued

Application Information

Product Image

Part Number 240 Volts

Watts

Heat Shield

Oil Heater

Required

Thread Size*

1” NPT

Chevrolet/GMC (Small Truck)

5.7L V8 (350 CID)

FC601-501

6.2L V8 Diesel 6.5L V8 Diesel

FC601-PY2

NONE

600

Mounts in the freeze plug in the engine’s block

No replacement cord available

Cummins

6 Cylinder Engines:

H, NT, NH, N Family 743 CID,855 CID,927 CID,“N14”

  • 1.

    Cummins engines are often referred to by their horsepower rating“i.e.350 Cummins”

  • 2.

    Cummins engines are often referred to as Big Cam,Big Cam2,3,4,full flow cooling,etc.

All refer to engines of 855 CID Size – listed below

Group I

Flat plate design

CUN-151B

CUN-152B

1500

Flat plate design when the 1/2”NPT opening is used

CUN-151BH

CUN-152BH

1500

6 bolt flat plate on the right side of the engine.May use either the forward or rear opening depending on clearance.

1” NPT

1” NPT

Group II

When an external oil cooler is used..

Note: When a 4 bolt flat plate element design is encountered,remove the next two bolts on the casting,remove the whole casting, and replace the casting and element with either CNT-151B/CNT-152B OR CNT151B90/CNT152B90

When connection is 1 1/2”rubber hose Engines produced Aug. 1975 thru June 1982

CNT-151B-90

CNT-152B-90

1500

6 bolt,flat plate design with an elbow that will rotate 360 degrees to connect with any hose or casting

1” NPT

CNT-151B

CNT-152B

1500

CUN-151BREV

CUN-152BREV

1500

PF151-002

PF152-002

1500

6 bolt,flat plate design with an elbow that will rotate 360 degrees to connect with any hose or casting

1” NPT

Six bolt flat plate on the right side of the block

1” NPT

Six bolt flat plate on the right side of the block

1” NPT

Uses an“O”ring for the 1 1/4”water tube connection Engines produced prior to August‘75

Group III

For industrial engines with hole pattern reversed

Group IV

1998 and later N14 Industrial

  • *

    If supplemental oil heating is desired, this column gives the correct thread size in oil pan. See NOTE on page 11.

6

Kim Hotstart Manufacturing Company, Inc.

P.O. Box 11245

Spokane, WA 99211-0245

Document info
Document views91
Page views97
Page last viewedThu Dec 08 03:14:32 UTC 2016
Pages24
Paragraphs1912
Words7545

Comments