slot so that the I/O module can then be safely removed without powering down the rack.
More Flexible Mounting Options
In addition to conventional 19-inch rail and panel- cutout mounting options, the 3500 System introduces a new bulkhead mounting option, allowing the rack to be mounted on a wall or other location where rear access to the rack is not available.
values) for a total of 32 in a single 4-channel monitor module. This is particularly valuable when machinery protection strategies require alarms on these proportional values. Activation or use of these proportional values has no impact on rack density, and does not consume additional channels in the monitor.
Note: ALERT alarm setpoints can be established on each proportional value, as desired. DANGER alarm setpoints can be established on any two proportional values returned from each channel.
Even without condition monitoring software, the 3500 System is able to provide more measurements from each transducer channel. For example, in addition to direct (unfiltered) vibration amplitude for a radial proximity probe channel, the 3500 monitor can return gap voltage, 1X amplitude and phase, 2X amplitude and phase, NOT 1X amplitude, and Smax amplitude (when XY transducers are present). Thus, a single radial vibration channel can actually return 8 conditioned parameters (termed proportional
Specifications Consult individual datasheets for each module type.
Ordering Information Consult individual datasheets for each module type.
Copyright 2002. Bently Nevada, LLC. 1631 Bently Parkway South, Minden, Nevada USA 89423
www.ge-energy.com/bently All rights reserved.
Bently Nevada , System 1, Data Manager, and Keyphasor are trademarks of the General Electric Company.
Modbus is a trademark of Modbus-ADI.
Specifications and Ordering Information Part Number 162096-01 Rev. F (03/07)
Page 12 of 12