X hits on this document

PDF document

WiPort Data Sheet - page 2 / 7

30 views

0 shares

0 downloads

0 comments

2 / 7

Protocol Support

The WiPort uses the widely accepted 802.11g protocol to connect to a wireless infrastructure or ad-hoc network, and is fully backward compatible with legacy 802.11b wireless networks. It uses the Transmission Control Protocol (TCP) to assure that no data is lost or duplicated and that everything sent to the connection arrives correctly at the target.

Other supported protocols are listed below:

  • ARP, UDP, TCP, ICMP, Telnet, TFTP, AutoIP, DHCP, HTTP, and SNMP for network communications.

  • TCP, UDP, and Telnet for connections to the serial port.

  • TFTP for firmware updates.

  • IP for addressing, routing, and data block handling

over the network.

  • User Datagram Protocol (UDP) for typical datagram

applications in which devices interact with other

devices without connection.

maintaining

a

point-to-point

Dimensions

  • The WiPort dimensions are shown in the

following drawing:

WiPort – Embedded Device Server (Note: Part #s on drawing are only representative)

WiPort b/g Data Sheet – Rev 1.0 (March 2006)

Page 2 of 7

Document info
Document views30
Page views30
Page last viewedSat Dec 03 10:00:11 UTC 2016
Pages7
Paragraphs351
Words1826

Comments