X hits on this document

202 views

0 shares

0 downloads

0 comments

34 / 62

MARTECH RCD PRO

6.4 RCDPRO_RNS510

Module designed to work with RNS510 (Siemens/VDO, Continental, Columbus) navigations

Required equipment:

  • -

    Martech CLIP with RCD PRO activation

  • -

    12V/3A power supply to power the radio

  • -

    LTTL to RS232 converter

  • -

    cable with 26pin connector for Navi system

      • 6.4.1

        Diagram connection scheme for RNS510

LTTL RS232 converter schematic you can find at www.martech.pl/forum. You can make it on the basis of standard MAX232, also. Power signal can be taken directly from pin1 of RJ45 PORT2 of CLIP.

There is no need to use Martech Expander for these units. In the absence of a plug-for navigation system, you can use a regular slot with the goldpins in 2.54mm pitch.

User manual

34

Document info
Document views202
Page views202
Page last viewedSun Dec 04 15:33:52 UTC 2016
Pages62
Paragraphs746
Words6181

Comments