X hits on this document

879 views

0 shares

0 downloads

0 comments

121 / 255

WARNING

TIGHTEN PAST 3 CLICKS

PREMIUM UNLEADED FUEL ONLY

To reduce the risk of any sudden discharge of fuel caused by excessive air pressure, the cap is designed to allow the fuel tank to vent during the first half turn. DO NOT fully remove the cap until any pressure has been released.

FAILURE TO TIGHTEN MAY CAUSE CHECK ENGINE LIGHT TO ILLUMINATE WLD100600

ESSENCE PREMIUM SANS PLOMB SEULEMENT

Take careful note of warning labels located around the filler flap.

F u e l F i l l i n g L O C K I N G A N D U N L O C K I N G T H E FUEL FILLER FLAP

Fuel Filling

H2649

When replacing, tighten the cap clockwise until you hear the fuel cap ratchet click at least three times. If the cap is not fitted correctly, the ‘Service engine soon’ warning light may illuminate.

H4536

The fuel filler is located in the rear right-hand wing. With the starter switch turned off, press the binnacle mounted switch (shown in illustration) to release the filler flap.

The filler cap is designed to allow the fuel tank to vent during the first half turn. Carefully loosen the cap one half turn until resistance is felt, and allow fuel tank pressure to be released. Once the pressure is released (hissing has stopped), it is safe to fully remove the filler cap.

120

Document info
Document views879
Page views879
Page last viewedWed Dec 07 20:21:18 UTC 2016
Pages255
Paragraphs4992
Words62569

Comments