X hits on this document

961 views

0 shares

0 downloads

0 comments

234 / 255

Bulb Replacement

BUMPER MOUNTED LIGHTS (Fog guard & reverse lights)

To re-fit the light unit to the bumper, first locate the hooks ‘C’ in the bumper aperture and firmly push the other side of the light against spring pressure until it clicks into place.

C

NUMBER PLATE LIGHTS

B A

H2499

H4394

WARNING

If the engine is warm, the exhaust system may be hot - to prevent personal injury, avoid contact with a hot exhaust system when reaching behind the bumper.

Remove both screws to release the light unit. Ease the light unit from its recess and pull the bulb to remove.

Reach behind the bumper and press the spring clip ‘A’ to release the light unit.

Squeeze both levers ‘B’ to release the bulb holder from the lens. Push and twist to release the bulbs.

NOTE: If necessary, the light unit can first be detached from the electrical harness by releasing the multi-plug from the rear of the bulb holder.

Replace the required bulb and re-fit the holder to the light unit.Before reassembling the light unit, make sure the seal (between holder and lens) is in place.

233

Document info
Document views961
Page views961
Page last viewedSat Dec 10 21:33:48 UTC 2016
Pages255
Paragraphs4992
Words62569

Comments