X hits on this document

818 views

0 shares

0 downloads

0 comments

42 / 255

Seats

Seat back adjustment

HEAD RESTRAINTS

WARNING

WARNING

DO NOT travel with the seat backs reclined steeply rearwards. Sit in the most upright position with the base of your spine as far back as possible and the seat back not reclined more than 30 degrees from the vertical.

Head restraints are designed to support the back of the head (NOT THE NECK), and to restrain rearward movement of the head in the event of a collision. The restraint must be positioned level with the head to be effective.

Twist the switch forward or backward until the desired seat back angle is achieved.

Pull the head restraint up or down until the cushion is level with the back of the head.

After replacing a head restraint turn the mounting collars clockwise.

H2627

H2465

Head restraint removal Turn both mounting collars fully anti-clockwise and pull the restraint upwards to remove.

Failure to maintain the correct seat back angle will reduce the effectiveness of the seat belts and increase the risk of serious injury or death in a crash.

DO NOT drive or carry passengers with the head restraints removed from occupied seats, or adjust the head restraints while the vehicle is in motion.

Failure to have the head restraint installed and properly positioned will increase the potential for serious injuries.

41

Document info
Document views818
Page views818
Page last viewedMon Dec 05 02:30:36 UTC 2016
Pages255
Paragraphs4992
Words62569

Comments