Parking brake, brake fluid - RED
Transmission oil temperature - RED*
The light illuminates for about 3 BRAKE seconds as a bulb check when the starter switch is turned on. It also illuminates when the parking brake is applied with the starter switch in position ‘II’.
The light should extinguish when the parking brake is fully released or shortly after the electrical circuits are switched on. If the light illuminates whilst driving, a fault with the braking system is indicated. Stop the vehicle as soon as safety permits and seek qualified assistance before continuing.
Do not drive the vehicle while the brake warning light is illuminated.
Illuminates as a bulb check when the starter switch is turned to position ‘II’ and extinguishes after 3 seconds approx. If the light illuminates while driving, the gearbox oil temperature is too high (most likely to occur in very hot weather during continuous high speed driving, or whilst towing heavy loads on steep inclines or if the parking brake has been applied while driving).
If the light illuminates, reduce speed. If the light remains on, stop the vehicle and allow the gearbox to cool. Do not drive until the light has extinguished. (Depending on the ambient temperature and the carrying loads imposed on the vehicle, it may take several minutes before the light extinguishes and it is safe to drive).
Anti-lock braking system - AMBER
Low oil pressure - RED
The light illuminates as a bulb check when the starter switch is turned to position ‘II’ and extinguishes when the engine is started. If the light remains on, flashes on and off, or illuminates whilst driving, stop the vehicle as soon as safety permits and SWITCH OFF THE ENGINE IMMEDIATELY. Seek qualified assistance before driving. Always check the oil level when this light illuminates.
CAUTION: Do not drive the vehicle while the low oil pressure light is illuminated.
The light illuminates as a bulb and system check when the starter switch is turned to position ‘II’. If the light illuminates whilst driving or remains illuminated after the starter switch is turned on, a fault has occurred. This means that full ABS control may not be available and you should seek qualified assistance urgently.
NOTE: Faults which cause the ABS light to illuminate after the initial system checks, or whilst driving, will be accompanied by a warning chime sounding 3 times.
Three warning chimes may also be heard during engine start-up as part of the ABS system self-checks. This is normal unless the ABS warning light stays illuminated after the engine is running.
Drive with extreme caution if the warning light is illuminated - ABS may not be working!