X hits on this document

1106 views

0 shares

0 downloads

0 comments

70 / 255

Warning Lights

Headlight high beam - BLUE Illuminates when the headlights are switched to main beam.

Direction indicators - GREEN

Off Road - AMBER* Illuminates briefly as a bulb and system check when the starter switch is turned to position ‘II’ and then extinguishes.

The left or right warning light flashes in time with the corresponding left or right direction indicator lights whenever they are operated. If the warning light fails to flash, or flashes very rapidly, this may indicate a bulb failure in one of the direction indicator lights.

If the off-road switch is pressed: The light flashes continually while the rear of the vehicle is either; rising to off-road height, or returning to standard ride height. The light illuminates constantly while the suspension remains at off-road height.

If the hazard switch is pressed, both warning lights will flash in conjunction with the direction indicator lights.

Trailer direction indicators - GREEN

The light illuminates briefly as a bulb check when the starter switch is turned to position ‘II’. If a trailer is attached, the light illuminates in conjunction with the vehicle direction indicator lights to show that all trailer indicator lights are functioning correctly. In the event of a bulb failure on the trailer, the warning light remains off.

Seat belt - RED

The light illuminates when the starter switch is turned to position ‘II’ and extinguishes after approximately 6 seconds, even if the driver's seat belt remains unfastened. Always fasten your seat belt before driving.

In addition, the light will flash if extended mode is induced.

Hill descent control (HDC) information- GREEN

Illuminates briefly as a bulb and system check when the starter switch is turned to position 'II' and also when HDC is selected.

If HDC is selected when Low Range gears are engaged the light will illuminate continuously indicating that HDC is active.

When HDC is selected and non-operating gears are engaged (i.e. High range), the light will flash to inform the driver that HDC is selected, but will not operate.

If the light starts to flash while HDC is active, normal functionality may cease and HDC ‘fade out’ may be induced (see ‘HILL DESCENT CONTROL’, page 138).

Battery charging - RED

The light illuminates as a bulb check when the starter switch is turned to position ‘II’ and extinguishes once the engine is running. If it remains on, or illuminates whilst driving, a fault is indicated. Seek qualified assistance urgently.

69

Document info
Document views1106
Page views1106
Page last viewedFri Jan 20 04:41:58 UTC 2017
Pages255
Paragraphs4992
Words62569

Comments