X hits on this document

765 views

0 shares

0 downloads

0 comments

77 / 255

Wipers & Washers

DO NOT operate the wipers on a dry screen.

In freezing or very hot conditions, ensure that the blades are not frozen or stuck to the glass.

In winter, remove any snow or ice from around the arms and blades, including the wiped area of the windshield and the heater air intakes.

H2450

1

3

IMPORTANT INFORMATION

2

W i p e r s & W a s h e r s O P E R A T I N G The wipers and washers will only operate when the starter switch is turned to position ‘I’ or ‘II’.

WINDSHIELD WIPERS

NOTE: If the wiper blades have stuck to the glass, a thermal cut-out may temporarily prevent the wiper motor from operating. If this is the case, switch the wipers off, free them from the obstruction and then switch on again.

Intermittent wipe Turn switch to position 1.

Normal speed wipe Turn switch to position 2.

Fast speed wipe Turn switch to position 3.

NOTE: If the front screen wipers are operating (in either intermittent or continuous mode), the rear wiper operates automatically whenever reverse gear is selected.

76

Document info
Document views765
Page views765
Page last viewedSat Dec 03 02:46:27 UTC 2016
Pages255
Paragraphs4992
Words62569

Comments