X hits on this document

67 views

0 shares

0 downloads

0 comments

19 / 27

3M™ EZ Sand Flexible Parts Repair PN 05887, 05891, 05892, 05895, 05896 - Accelerator

02/05/14

No unusual fire or explosion hazards are anticipated.

SECTION 6: Accidental release measures

6.1. Personal precautions, protective equipment and emergency procedures Evacuate area. Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or vapors in the spill area to burn or explode. Refer to other sections of this SDS for information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.

6.2. Environmental precautions Avoid release to the environment.

6.3. Methods and material for containment and cleaning up Collect as much of the spilled material as possible. Place in a closed container approved for transportation by appropriate authorities. Clean up residue with an appropriate solvent selected by a qualified and authorized person. Ventilate the area with fresh air. Read and follow safety precautions on the solvent label and SDS. Clean up residue. Seal the container. Dispose of collected material as soon as possible.

SECTION 7: Handling and storage

7.1. Precautions for safe handling Keep out of reach of children. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Use personal protective equipment (gloves, respirators, etc.) as required.

7.2. Conditions for safe storage including any incompatibilities Keep container tightly closed. Store away from heat. Store away from acids. Store away from oxidizing agents.

SECTION 8: Exposure controls/personal protection

8.1. Control parameters

Occupational exposure limits

Ingredient Limestone

Titanium Dioxide

Titanium Dioxide

Titanium Dioxide

Talc

Talc

Talc

C.A.S. No.

Agency

1317-65-3

US Dept of

Labor - OSHA

13463-67-7 Amer Conf of Gov. Indust. Hyg. 13463-67-7 Chemical Manufacturer Rec Guid 13463-67-7 US Dept of Labor - OSHA 14807-96-6 Amer Conf of Gov. Indust. Hyg. 14807-96-6 Chemical Manufacturer Rec Guid 14807-96-6 US Dept of

Limit type TWA(as total dust):15 mg/m3;TWA(respirable fraction):5 mg/m3 TWA:10 mg/m3

TWA(as respirable dust):5 mg/m3

TWA(as total dust):15 mg/m3

TWA(respirable fraction):2 mg/m3

TWA(as respirable dust):0.5 mg/m3

TWA concentration(as total

Additional Comments

Page 4 of 12

Document info
Document views67
Page views67
Page last viewedThu Dec 08 10:21:58 UTC 2016
Pages27
Paragraphs1114
Words8667

Comments