X hits on this document

66 views

0 shares

0 downloads

0 comments

20 / 27

3M™ EZ Sand Flexible Parts Repair PN 05887, 05891, 05892, 05895, 05896 - Accelerator

02/05/14

Quartz Silica

Quartz Silica

Oxide Glass Chemicals

Tris(2,4,6-

65997-17-3

Manufacturer

TWA(as dust):10 mg/m3

determined

90-72-2

Chemical

TWA:5 ppm

Labor - OSHA

14808-60-7 Amer Conf of Gov. Indust. Hyg. 14808-60-7 US Dept of Labor - OSHA

dust):0.3 mg/m3;TWA concentration(respirable):0.1 mg/m3(2.4 millions of particles/cu. ft.);TWA:20 millions of particles/cu. ft. TWA(respirable fraction):0.025 mg/m3

TWA concentration(as total dust):0.3 mg/m3;TWA concentration(respirable):0.1 mg/m3(2.4 millions of particles/cu. ft.)

Dimethylaminomonomethyl)Phen

Manufacturer

ol

Rec Guid

Amer Conf of Gov. Indust. Hyg. : American Conference of Governmental Industrial Hygienists American Indust. Hygiene Assoc : American Industrial Hygiene Association Chemical Manufacturer Rec Guid : Chemical Manufacturer's Recommended Guidelines US Dept of Labor - OSHA : United States Department of Labor - Occupational Safety and Health Administration TWA: Time-Weighted-Average STEL: Short Term Exposure Limit CEIL: Ceiling

    • 8.2.

      Exposure controls

      • 8.2.1.

        Engineering controls

Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment. Provide appropriate local exhaust ventilation for cutting, grinding, sanding or machining.

8.2.2. Personal protective equipment (PPE)

Eye/face protection

Wear eye/face protection. Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face protection(s) are recommended: Full Face Shield Indirect Vented Goggles

Skin/hand protection Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing. Wear protective gloves. Gloves made from the following material(s) are recommended: Butyl Rubber Nitrile Rubber

Respiratory protection

In case of inadequate ventilation wear respiratory protection. An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure: Half facepiece or full facepiece air-purifying respirator suitable for organic vapors and particulates

Page 5 of 12

Document info
Document views66
Page views66
Page last viewedThu Dec 08 04:25:42 UTC 2016
Pages27
Paragraphs1114
Words8667

Comments