X hits on this document

60 views

0 shares

0 downloads

0 comments

6 / 27

3M™ EZ Sand Flexible Parts Repair PN 05887, 05891, 05893, 05895, 05896 - Part B (Base)

02/06/14

SECTION 6: Accidental release measures

6.1. Personal precautions, protective equipment and emergency procedures Evacuate area. Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or vapors in the spill area to burn or explode. Refer to other sections of this SDS for information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.

6.2. Environmental precautions Avoid release to the environment.

6.3. Methods and material for containment and cleaning up Collect as much of the spilled material as possible. Place in a closed container approved for transportation by appropriate authorities. Clean up residue. Seal the container. Dispose of collected material as soon as possible.

SECTION 7: Handling and storage

7.1. Precautions for safe handling Keep out of reach of children. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace. Avoid release to the environment. Wash contaminated clothing before reuse. Use personal protective equipment (gloves, respirators, etc.) as required.

7.2. Conditions for safe storage including any incompatibilities Keep container tightly closed. Store away from heat. Store away from acids.

SECTION 8: Exposure controls/personal protection

8.1. Control parameters

Occupational exposure limits

Ingredient Epichlorohydrin

Epichlorohydrin

Limestone

Carbon Black

Carbon Black

Carbon Black

Talc

C.A.S. No. 106-89-8

106-89-8

1317-65-3

1333-86-4

1333-86-4

1333-86-4

14807-96-6

Agency Amer Conf of Gov. Indust. Hyg. US Dept of Labor - OSHA US Dept of Labor - OSHA

Amer Conf of Gov. Indust. Hyg. Chemical Manufacturer Rec Guid US Dept of Labor - OSHA Amer Conf of Gov. Indust. Hyg.

Limit type TWA:0.5 ppm

TWA:19 mg/m3(5 ppm)

TWA(as total dust):15 mg/m3;TWA(respirable fraction):5 mg/m3 TWA(inhalable fraction):3 mg/m3

TWA:0.5 mg/m3

TWA:3.5 mg/m3

TWA(respirable fraction):2 mg/m3

Additional Comments Skin Notation

Skin Notation

Page 4 of 13

Document info
Document views60
Page views60
Page last viewedMon Dec 05 04:53:05 UTC 2016
Pages27
Paragraphs1114
Words8667

Comments