X hits on this document

58 views

0 shares

0 downloads

0 comments

7 / 27

3M™ EZ Sand Flexible Parts Repair PN 05887, 05891, 05893, 05895, 05896 - Part B (Base)

02/06/14

Talc

Talc

Quartz Silica

Quartz Silica

STEARATES

Oxide Glass Chemicals

14807-96-6 Chemical Manufacturer Rec Guid 14807-96-6 US Dept of Labor - OSHA

14808-60-7 Amer Conf of Gov. Indust. Hyg. 14808-60-7 US Dept of Labor - OSHA

Amer Conf of Gov. Indust. Hyg. 65997-17-3 Manufacturer 57-11-4

TWA(as respirable dust):0.5 mg/m3

TWA concentration(as total dust):0.3 mg/m3;TWA concentration(respirable):0.1 mg/m3(2.4 millions of particles/cu. ft.);TWA:20 millions of particles/cu. ft. TWA(respirable fraction):0.025 mg/m3

TWA concentration(as total dust):0.3 mg/m3;TWA concentration(respirable):0.1 mg/m3(2.4 millions of particles/cu. ft.) TWA:10 mg/m3

TWA(as dust):10 mg/m3

Filler

SILICA, AMORPHOUS

Mixture

Mixture

determined Chemical Manufacturer Rec Guid US Dept of Labor - OSHA

CEIL:5 mg/m3

TWA concentration:0.8 mg/m3;TWA:20 millions of particles/cu. ft.

Amer Conf of Gov. Indust. Hyg. : American Conference of Governmental Industrial Hygienists American Indust. Hygiene Assoc : American Industrial Hygiene Association Chemical Manufacturer Rec Guid : Chemical Manufacturer's Recommended Guidelines US Dept of Labor - OSHA : United States Department of Labor - Occupational Safety and Health Administration TWA: Time-Weighted-Average STEL: Short Term Exposure Limit CEIL: Ceiling

8.2. Exposure controls

8.2.1. Engineering controls Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment. Provide appropriate local exhaust ventilation for cutting, grinding, sanding or machining.

8.2.2. Personal protective equipment (PPE)

Eye/face protection

Wear eye/face protection. Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face protection(s) are recommended: Indirect Vented Goggles

Skin/hand protection Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing. Wear protective gloves.

Page 5 of 13

Document info
Document views58
Page views58
Page last viewedSun Dec 04 10:34:17 UTC 2016
Pages27
Paragraphs1114
Words8667

Comments