X hits on this document

61 views

0 shares

0 downloads

0 comments

8 / 27

3M™ EZ Sand Flexible Parts Repair PN 05887, 05891, 05893, 05895, 05896 - Part B (Base)

02/06/14

Gloves made from the following material(s) are recommended: Polymer laminate

Apron - polymer laminate

Respiratory protection

In case of inadequate ventilation wear respiratory protection. An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure: Half facepiece or full facepiece air-purifying respirator suitable for organic vapors and particulates

For questions about suitability for a specific application, consult with your respirator manufacturer.

SECTION 9: Physical and chemical properties

9.1. Information on basic physical and chemical General Physical Form: Specific Physical Form: Odor, Color, Grade: Odor threshold pH Melting point Boiling Point Evaporation rate Flammability (solid, gas) Flammable Limits(LEL) Flammable Limits(UEL) Vapor Pressure Vapor Density Density Specific Gravity Solubility in Water Partition coefficient: n-octanol/ water Autoignition temperature Decomposition temperature Viscosity Hazardous Air Pollutants Volatile Organic Compounds Volatile Organic Compounds Percent volatile VOC Less H2O & Exempt Solvents

properties Solid Paste Black, with little odor No Data Available Not Applicable No Data Available Not Applicable No Data Available Not Classified Not Applicable Not Applicable No Data Available No Data Available 1.0 - 1.5 g/ml 1.0 - 1.5 [Ref Std: WATER=1] Nil No Data Available No Data Available No Data Available 40 - 110 sec [Details: Pressflow Viscosity] 0.011 % weight [Test Method: Calculated] 1 g/l [Test Method: calculated SCAQMD rule 443.1]

    • 0.1

      % weight [Test Method: calculated per CARB title 2]

    • 0.1

      % weight

1 g/l [Test Method: calculated SCAQMD rule 443.1]

SECTION 10: Stability and reactivity

10.1. Reactivity This material may be reactive with certain agents under certain conditions - see the remaining headings in this section.

10.2. Chemical stability Stable.

10.3. Possibility of hazardous reactions Hazardous polymerization will not occur.

10.4. Conditions to avoid

Page 6 of 13

Document info
Document views61
Page views61
Page last viewedTue Dec 06 09:31:47 UTC 2016
Pages27
Paragraphs1114
Words8667

Comments