X hits on this document

134 views

0 shares

0 downloads

0 comments

12 / 62

12

Connections to Your TV

  • Make one of the following connections, depending on the capabilities of your existing equipment.

  • When using the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks, set the VIDEO OUTPUT switch to COMPONENT. When using the SCART jack, set the VIDEO OUTPUT switch to RGB.

T i p s Depending on your TV and other equipment you wish to connect, there are various ways you could connect the recorder. Use only one of the connections described below. Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.

Caution

  • Make sure the recorder is connected directly to the TV. Tune the TV to the correct video input channel.

  • Do not connect the recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

  • Do not connect your recorder via your VCR. The DVD image could be distorted by the copy protection system.

Rear of TV

SCART INPUT

AUDIO INPUT

VIDEO INPUT

COMPONENT VIDEO INPUT

L

R

Y

Pb

Pr

A

V

C

T

Rear of the recorder

SCART connection

Connect the EURO AV1 AUDIO/VIDEO scart jack on the recorder to the corresponding in jacks on the TV using the scart cable (T).

Video connection

Connect the VIDEO OUT jack on the recorder to the video in jack on the TV using the video cable (V).

Component Video connection

Connect the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks on the recorder to the corresponding input jacks on the TV using an Y Pb Pr cable (C).

Progressive Scan connection

If your television is a high-definition or “digital ready” television, you may take advantage of the recorder’s progressive scan output for the highest video resolution possible. If your TV does not accept the Progressive Scan format, the picture will appear scrambled if you try Progressive Scan on the recorder.

Connect the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks on the recorder to the corresponding in jacks on the TV using the Y Pb Pr cable (C).

Notes:

  • Set the Progressive to [ON] on the setup menu for progressive signal, see page 19.

  • Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack). Caution

Once the setting for Progressive Scan output is entered, an image will only be visible on a Progressive Scan compatible TV or monitor. If you set Progressive Scan to [ON] in error, you must reset the recorder. First, remove the disc in the recorder. Next, press STOP (x) and hold it for five seconds before releasing it. The video output will be restored to the standard setting, and a picture will once again be visible on a conventional analog TV or monitor.

Audio (Left/Right) Connection Connect the left and right AUDIO OUT jacks of the recorder to the audio left and right IN jacks on the TV using the audio cables (A). Do not connect the recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

Document info
Document views134
Page views134
Page last viewedSun Dec 04 22:42:10 UTC 2016
Pages62
Paragraphs3108
Words28891

Comments