X hits on this document

219 views

0 shares

0 downloads

0 comments

23 / 62

DV Recording Audio

Disc Settings

You need to set this if you have a camcorder using 32kHz/12-bit sound connected to the front panel DV IN jack. Some digital camcorders have two stereo tracks for audio. One is recorded at the time of shooting; the other is for overdubbing after shooting. On the Audio 1 setting, the sound that was recorded while shooting is used. On the Audio 2 setting, the overdubbed sound is used.

Disc Format

If you load a completely blank disc, the recorder will initialize the disc. DVD-R: The recorder initialize the disc to Video mode. The recording mode will always be Video mode. DVD-RW: The recorder initialize the disc to VR mode. DVD+R (DL): The Initialize menu will appears. Select “Yes” then press ENTER. DVD+RW: The recorder initialize the disc to DVD+RW mode. Also, you can reformat the DVD-RW/DVD+RW from the Setup menu as below.

TV Recording Audio

When TV recording with bilingual, you can choose audio channel to record. [Main+Sub] Main language and Sub language [Main] Main language only [Sub] Sub language only

  • 1.

    Select [Disc Format] option then press B.

  • 2.

    Press ENTER while [Start] is selected.

Format Disc menu appears.

Auto Chapter

  • 3.

    Use b / B to select a desired mode (VR Mode or Video Mode) then press ENTER. Confirm message will appear. For DVD+RWs, go to step 4.

  • 4.

    Use b / B to select [Ok] then press ENTER. It takes a few moments to initialize the disc.

When recording in Video mode, chapter markers are put in specified setting. You can change this interval to 5 minutes, 10 minutes or 15 minutes. If you select [None], switch off automatic chapter marking altogether with the [None] setting.

Caution

If you want to change the disc format, everything recorded on the disc will be erased.

23

Hookup and Settings

Document info
Document views219
Page views219
Page last viewedSun Jan 22 06:13:41 UTC 2017
Pages62
Paragraphs3108
Words28891

Comments