X hits on this document

PDF document

Operating Instructions - page 12 / 60

212 views

0 shares

0 downloads

0 comments

12 / 60

Before using

The grip belt

Power supply

Adjust the belt length so it fits your hand. 1 Adjust the belt length and the pad position.

ª Charging the battery

When this product is purchased, the battery is not charged. Charge the battery before using this product.

IMPORTANT: If the DC Cable is connected to the AC adaptor,

then the battery will not get charged. Remove the DC Cable from the AC adaptor.

Battery charging time. (-13-) We recommend using Panasonic batteries.

(-8-, -51-) If you use other batteries, we cannot guarantee

1 Flip the belt. 2 Adjust the length. 3 Fix the belt.

the quality of this product.

1 Connect the AC Cable to the AC adaptor and the AC Jack.

Using the lens cover

2 Insert the battery into the battery charger by aligning the arrows.

For the lens protection, be sure to close the lens cover when not in use.

1

Slide the lens cover open/close switch to

[

].

2

1

ª Charging lamp [CHARGE]

Lights up:Charging Goes off: Charging completed Flashing: When the battery temperature is excessively high or low, the lamp flashes and the charging time will be longer than normal. Remove dirt, foreign objects or dust on the terminals of the battery or the AC adaptor. If the lamp is still flashing, something may be wrong with the battery or AC adaptor. Contact consumer support. -55-

CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

12

LSQT1284

Document info
Document views212
Page views212
Page last viewedSun Dec 04 08:57:02 UTC 2016
Pages60
Paragraphs1619
Words19264

Comments