X hits on this document

PDF document

Operating Instructions - page 18 / 60

252 views

0 shares

0 downloads

0 comments

18 / 60

Before using

Inserting/removing a cassette

1 Fit the AC adaptor or the battery and turn on the power.

2 Slide the [OPEN/EJECT] lever and open the cassette cover.

OPEN/ EJECT

After use, be sure to rewind the cassette completely, remove it and put it in a case. Store the case in an upright position. (-48-) If the indicator of the condensation does not display on the LCD screen and/or EVF and you notice condensation on the lens or the main unit, do not open the cassette cover otherwise condensation may be formed on the heads or the cassette tape. (-46-)

ª When the cassette holder does not come out

When the cover is fully opened, the cassette holder will come out.

3 After the cassette holder is opened, insert/ remove the cassette.

Close the cassette cover completely, and then open it again completely. Check if the battery has run down. Check if the cassette compartment cover is in contact with grip belt as shown below. If so, be sure the grip belt stays clear of the cover when opening.

1

Set the mode dial to OFF, then to another mode again. Check if the battery has run down.

PUSH

ª Accidental erasure prevention

When inserting a cassette, orient it as shown

in the figure, and then securely insert it as far as it goes. When removing, pull it straight out.

4 Push the [PUSH] mark 1 in order to close the cassette holder. The cassette holder is housed.

Caution: Take care not to trap your fingers under the cassette holder when closing it.

5 Only after the cassette holder is completely housed, close the cassette cover tightly.

When inserting a previously recorded cassette, use the blank search function to find the position where you want to continue recording. If you are overwriting a previously recorded cassette, be sure to find the position where you want to continue recording. When closing the cassette cover, do not get anything, such as a cable, caught in the cover.

18

LSQT1284

ª When the cassette holder cannot be housed

If the accidental erasure prevention slider 1 of a cassette is opened (slide in the direction of the [SAVE] arrow), the cassette cannot be recorded. When recording, close the accidental erasure prevention slider of the cassette (slide in the direction of the [REC] arrow).

REC

SAVE

1

Document info
Document views252
Page views252
Page last viewedSat Dec 10 05:55:43 UTC 2016
Pages60
Paragraphs1619
Words19264

Comments