X hits on this document

PDF document

Operating Instructions - page 25 / 60

209 views

0 shares

0 downloads

0 comments

25 / 60

Record mode

Recording check

Blank search function

The last image recorded is played back for 2 to 3 seconds. After checking, the Camcorder will be set to recording pause. Set to Tape Recording Mode.

1 Press the joystick to display the icon during the recording pause. Move the joystick down until icon 1 appears.

2 Move the joystick left to select the

Searches for the last part of the image recorded (unused part of the tape). After the search is finished, the blank search function is canceled and the Camcorder is put into recording pause. Set to Tape Recording Mode.

1 Press the joystick to display the icon during the recording pause. Move the joystick down until icon 1 appears.

recording check icon [

].

2 Move the joystick right to select the blank

search icon [

].

1

1

The [RECORDING CHECK STARTED] indication appears on the screen of the Camcorder.

3 When the confirmation message appears, select [YES] and press the center of the joystick.

ª Stopping blank search midway through

Move the joystick down to select the [] icon.

If the cassette tape has no blank part, then the Camcorder will stop at the end of the tape. The Camcorder stops at a point approx. 1 second before the end of the last image recorded. When you start recording at that point, the image can be recorded seamlessly from the last image.

25

LSQT1284

Document info
Document views209
Page views209
Page last viewedSun Dec 04 04:39:44 UTC 2016
Pages60
Paragraphs1619
Words19264

Comments