X hits on this document

48 views

0 shares

0 downloads

0 comments

15 / 18

Fig. 24

15) Select Tools >Program­mer to reach the window in Figure 25. In the Mode box select Active Serial Programming as shown in Fig. 26. If you are changing the mode from the previously set JTAG mode, the pop-up box will appear, asking if you want to clear all devices. Click Yes. Make sure that the Hardware Setup indicates the USB-Blaster. You can setup the Hardware as shown in Fig. 27. If the configuration file is not already listed in the window, press Add File. The pop-up box will appear. Select the file .pof of the project designed form your working directory and click Open. As a result, the configuration file .pof will be listed in the window. This is a binary file produced by the Compiler’s Assembler module, which contains the data to be loaded into the EPCS16 configuration device. The extension .pof stands for Programmer Object File. Upon returning to the Programmer window, click on the Program/Configure check box, as shown. Press Start in the window in Figure 28. An LED on the board will light up when the configuration data has been downloaded successfully. Also, the Progress box in Figure 29 will indicate when the configuration and programming process is complete.

Document info
Document views48
Page views48
Page last viewedSun Dec 04 10:15:08 UTC 2016
Pages18
Paragraphs47
Words1658

Comments