X hits on this document

Powerpoint document

Power of Ethernet Direct PoE Product Line Overview - page 11 / 20

65 views

0 shares

0 downloads

0 comments

11 / 20

11

PoE Product Line Introduction Managed PoE Switch (PoE Software settings)

Maximum Power Available: Displays the maximum power supply in watts.

Actual Power Consumption: This column shows the real-time total power consumption

System Power Limit: User can modify the value to this column field to limit the total output power for the system

Main Supply Voltage: This column shows the output voltage of the system for PoE ports

Firmware Version: This column shows the PoE chip’s firmware version

Port Knockoff Disabled: Power Management state where one or more PDs have been powered down so that a higher priority PD may be powered up and yet not exceed the maximum total power available for PDs

AC Disconnect: Tick this checkbox to monitor the AC impedance on the port terminals and removes power when the impedance rises above a certain value, for a certain period

Capacitive Detection: If the port and capacitive detection are enabled, the capacitances state reads in the voltage result from the constant current. This is then subtracted from the pre-capacitance voltage to get a charge rate. If this charge rate is within the window of the PD signatures, the device is considered to be discovered.

Start: Showing with a tick symbol, the system initializes and resets successfully

Document info
Document views65
Page views65
Page last viewedMon Dec 05 07:18:24 UTC 2016
Pages20
Paragraphs281
Words1552

Comments