X hits on this document

PDF document

Weather Light Model: BAR210 / BAR210U / BAR210A - page 3 / 8

21 views

0 shares

0 downloads

0 comments

3 / 8

1.

/

: Increase / decrease setting; activate /

deactivate clock reception signal

  • 2.

    RESET: Reset unit to default settings

  • 3.

    AUTO ON / OFF: Select auto toggle mode

  • 4.

    CLOCK: Set time and display mode

  • 5.

    °C / °F: Select temperature unit and display mode

  • 6.

    Battery compartment

REMOTE SENSOR

  • 1.

    LED status indicator

  • 2.

    Wall mount hole

  • 3.

    Battery compartment

  • 4.

    RESET hole

  • 5.

    CHANNEL switch

GETTING STARTED

POWER SUPPLY Batteries serve as back up power supply for the clock.

For continuous use of LCD backlight, always plug in the adapter socket. Make sure the socket outlet is easily accessible to the unit.

To insert batteries:

1. Remove the battery compartment and insert the batteries, matching the polarities. 2. Press RESET after each battery change.

indicates main unit batteries are low.

REMOTE SENSOR

The main unit can be connected to only 1 remote sensor.

To set up the outside sensor:

  • 1.

    Open the battery compartment.

  • 2.

    Select a channel then press RESET.

  • 3.

    Close the battery door.

  • 4.

    Place the outside sensor within 30 m (98 ft) of the

main unit using the table stand or wall mount.

TIP The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results.

3

EN

Document info
Document views21
Page views21
Page last viewedFri Dec 09 12:33:56 UTC 2016
Pages8
Paragraphs260
Words1652

Comments