X hits on this document

102 views

0 shares

0 downloads

0 comments

40 / 50

Installing the Power Receptacle Box - North American Models

DANGER: To prevent serious injury or death, the electric standby power cord must not be connected to the receptacle box during installation!

NOTE: Choose an appropriate location for the Power Receptacle Box.

Side Mount (Detail A)

  • 1.

    Remove cover.

  • 2.

    Remove two hole plugs from base. Measure and drill two appropriate

size holes into truck body.

  • 3.

    Insert rubber blind nuts into hole in truck body.

  • 4.

    Install base and fasten with appropriate hardware. Install hole plugs

into unused mounting holes and reinstall cover. 5. Route and secure harness with supplied clamps.

Flush Mount (Detail B)

  • 6.

    Remove cover.

  • 7.

    Measure and drill two appropriate size holes into truck body.

  • 8.

    Insert rubber blind nuts into hole in truck body.

  • 9.

    Install base and fasten with appropriate hardware. Reinstall cover.

  • 10.

    Route and secure harness with supplied clamps.

40

Document info
Document views102
Page views102
Page last viewedSat Dec 03 18:33:08 UTC 2016
Pages50
Paragraphs453
Words4996

Comments